Wanted to share CURA 3d print settings that I found helpful for better prints. Eliminated fitting/reaming I had to do on mags so they'd spin freely.
Iniital Layer is for removing elephants foot. Hole is for making the holes slightly bigger so mags fit together better. Seam alignment is just do it quick vs a specific spot.
This combing reduces the travel:
If you use supports, the default 45 is too low. 60 is usually easy to do and results in smaller and fewer supports.
Slicing tolerance exclusive also helps to keep posts/holes from being too tight. Infill optimization is just for faster prints at the expense of slightly slower slicing.
Iniital Layer is for removing elephants foot. Hole is for making the holes slightly bigger so mags fit together better. Seam alignment is just do it quick vs a specific spot.
This combing reduces the travel:
If you use supports, the default 45 is too low. 60 is usually easy to do and results in smaller and fewer supports.
Slicing tolerance exclusive also helps to keep posts/holes from being too tight. Infill optimization is just for faster prints at the expense of slightly slower slicing.