Hi all,
After years of work my custom marauder is finally finished. the barrel and breech was made over at Jefferson State Air Rifles back in 2019 when they were still doing custom work and they could not have done a better job.
Specs:
.- 20in .357 threaded Lothar Walther unchoked barrel
-.high flowing valve drilled for a half inch port
-JSAR light weight air tube
-JSAR super hammer
-15lb hammer spring
-Armada stock
-3-9x32AOL scope.
I do have a DonnyFl 10.5in emperor suppressor for it, but the threads on the suppressor unfortunately are stripped so I have to order a new cap for it. I'm getting around 5 Accurate shots at 3000psi. it's sending 142gr hollow point slugs from NSA at around 840 fps at 3000psi, and 130gr VIP sabot slugs are around 870. a photo of the groupings @ 50yds will be down below. feel free to ask questions and or let me know some possible ammo suggestions
After years of work my custom marauder is finally finished. the barrel and breech was made over at Jefferson State Air Rifles back in 2019 when they were still doing custom work and they could not have done a better job.
Specs:
.- 20in .357 threaded Lothar Walther unchoked barrel
-.high flowing valve drilled for a half inch port
-JSAR light weight air tube
-JSAR super hammer
-15lb hammer spring
-Armada stock
-3-9x32AOL scope.
I do have a DonnyFl 10.5in emperor suppressor for it, but the threads on the suppressor unfortunately are stripped so I have to order a new cap for it. I'm getting around 5 Accurate shots at 3000psi. it's sending 142gr hollow point slugs from NSA at around 840 fps at 3000psi, and 130gr VIP sabot slugs are around 870. a photo of the groupings @ 50yds will be down below. feel free to ask questions and or let me know some possible ammo suggestions