I polished my barrel over the weekend, and I will have to shoot some groups to verify that it got rid of the flyer issue I mentioned on another thread. I do intend on buying a slug barrel in the future to make this a more long range setup.
I did purchase a huma regulator set to 145bar, power plenum, and power hammer spring that will arrive today or tomorrow. My question is whether to install these items now or wait till I have the barrel?
I have heard individuals say not to mess with the stock reg, bug I do not know what it is set. I currently launch 33.95 JSB pellets at about 900 FPS with the hammer spring maxed. I figured if I was already taking the air tube off this would be a good time to swap, and I could get the stock one set at a known value as a spare. It never hurts to have spare parts available.
At a minimum, I plan on swapping out the spring when the parts arrive.
Thoughts?
I did purchase a huma regulator set to 145bar, power plenum, and power hammer spring that will arrive today or tomorrow. My question is whether to install these items now or wait till I have the barrel?
I have heard individuals say not to mess with the stock reg, bug I do not know what it is set. I currently launch 33.95 JSB pellets at about 900 FPS with the hammer spring maxed. I figured if I was already taking the air tube off this would be a good time to swap, and I could get the stock one set at a known value as a spare. It never hurts to have spare parts available.
At a minimum, I plan on swapping out the spring when the parts arrive.
Thoughts?