.25 Marauder HDD or TSS?

[Wager]

Cool, thanks DairyBoy that was going to be my next question. Can't wait to see some of your numbers!!!

 

[Dairyboy]

Just heard 2 sets of spring are sent a stiffer set for higher power and softer for your typical power.

 

[OldCorps]

"JohnL57"I'd like to see the installation instructions-does anyone have a link?
John

That's what I'd like to see as well. Step by step instructions with pics for dummies like me. Never saw any for the SSG either..........

Ed

 

[Dairyboy]

The SSG was alittle complicated to understand this is as simple as replacing a hammer spring in an Mrod. Simply remove rear trigger bolt and if gen II remove the rear 2 breech screws (don't have gen I so can't comment on removing end cap) take out end cap and spring replace with new springs and new endcap and put back together.

 

[Jayman07770]

Travis just put up a video on YouTube about the TSS. 

 

[JohnL57]

Thanks for that-I will watch to see what kind of shot count others are getting with the TSS.

 

[Jimborg]

I just installed the ssg in my marauder a few months ago and now there is this tss thing. Is it that much better then the ssg to warrant replacing it after spending the money on the ssg ? 

 

[Jayman07770]

Just did the ssg on both my Mrods too. I'm pretty satisfied with the results and only spent $5 in parts. Unless I need theTSS for a special tune. I'm going to save my money for another project. 

 

[addertooth]

I think Dairyboy will be a good yardstick for this product. His air rifles are already stoked out with modifications, and his shot strings (before TSS) have already been posted to the forum. This will give a very clear before, and after comparison. After the this iteration of hammer bounce control design, Marauder owners will probably have to consider an electronic hammer to get much more in the way of gains.