13mm to Picatinny rail adapter

[cstar]

I have an HW 75 that is supposed to have an 11mm rail, but in reality I believe it is closer to 13 mm. 


Mounting an 11mm rail adapter results in the rail leaning noticeably to one side which is unacceptable. Searching the web for a 13mm to Picatinny rail adapter has not been much help. Pretty much everything is designed for 11mm. 


Any suggestions?

 

[8thman]

I believe that it was amazon that has picatinny down to an 11mm , and I had to buy two of them to accommodate the mounts. If remember correctly that they were about $7.00 bucks each.

 

[Odoyle]

This should work and no scope stop needed. Opens a lot wider than you need and self centering.

https://www.pyramydair.com/s/a/BKL_3_8_or_11mm_Dovetail_to_Weaver_Adapter_4_Long_Matte_Black/2923

 

[cstar]

I fixed the original post. The rail in question is on an HW 75.

 

[cstar]

I’m going to try one of the spring loaded minis. Since it’s going on a gun with little or no recoil I’m hoping it will hold up. At least it will be centered and low profile. 


Corky

 

[heavyw8]

BKL are the best in my opinion 

 

[heavyw8]

Here's another budget mount it has built in drop compensation and recoil stop pin

 

[cstar]

heavyw8, What website has the BSA adapter? That one is too long for my needs but they might have a shorter one. 


It appears to be a UK based shop since the price is in Pounds. Often times they don’t ship to the US. 


Corky

 

[cstar]

heavyw8, I found it. Eagle Vision. 


thanks

 

[Feinwerk]

It's been a long time but I think I used the spring loaded UTG mini adapters on my P2/HW75. They open surprisingly far. Good for when you don't want the extra height of a riser.

https://www.pyramydair.com/s/a/UTG_11mm_3_8_Dovetail_to_Weaver_Adapter_2pcs/4148

 

[cstar]

Feinwerk, That’s exactly what I ordered. It should self center and be tightened securely by the screws in the mount for the red dot.  

 

[heavyw8]

NP ....glad to help out 

 

[Odoyle]

The PA UTG low profile adapters may self center on a 13mm dovetail but what about the rings that clamp above them are They self centering as well? They won't be able to close properly since the UTG gets wider at the top Picatinny as well and may be offset to one side?

The BKL is the only sure fire way IMHO.

Otherwise a BSA 13mm dovetail mount would work.