110 bar FX regulator?

[sweron]

Hi guys,
I know this is a long shot since the majority of you probably are shootings at max settings, but can anyone of you tell me the number of Belleville washers on the 110 bar FX regulator? In the FX drawings it's called 19043-110, and should be the same as the normal (140 bar) regulator, with the exception of number of washers (my 140 bar regulator has 7). I am fully aware of the problems of getting the exact settings on these regulators, but that I can handle. Me question right now is about the number of washers.

 

[dreuf]

I was not aware of a specific 110 bar reg with less washers.

for information on my 2 fx rifles (boss and glad mk2) the regs can be set up at lower pressure by unscrewing the brass screw as low as you need. By acident i already got it set up at 80 bar for example.

My 2 regs have 8 washers.

hope it helps.

 

[sweron]

Dreuf, are you referring to the brass screw (positioned between regulator body and the washers) that holds the piston and allows for the piston movement? I haven't tried adjusting that.
At 140 bars my (7) washers are compressed as little as possible, meaning I can not lower the pressure the normal way (lessening the washer compression).

 

[dreuf]

I was talking about the normal compression screw sorry for the wording issue. It is weird if you have almost no compression the reg should close at a very low pressure....

try to release to 0 the compression and normally the reg should close well below 100b. If not -> reg is leaking somewhere 

 

[dreuf]

You may also check the piston travel (it can be set by the bigger brass screw between reg boddy and washers). If it is a bit too long it will require more pressure to close.