Search results for query: *

I have a Crown MK1 .25 cal 600 mm that I have been shooting for 5 1/2 years. I want to install a .22 cal FX Crown STX Superlight 600 mm barrel. This barrel is advertised with a shroud and no moderator. Will there be any difference in loudness shooting with this barrel system compared to what I...

For anyone with experience shooting slugs through an FX Crown MK I, I am interested to know if there is any advantage in shooting slugs with a .22 cal over a .25 cal. I have a .25 cal now, and am considering buying a .22 cal barrel for the cost saving of buying pellets and slugs, along with air...

I have an FX Crown MKI .25 that I have been trying to shoot slugs as accurate as I can. Most of what I've read mentions more velocity with slugs for the best accuracy. My tune is maxed out for the most velocity I can get at 145 bar is 850 fps. I'm presently shooting NSA 33.5 grain slugs with...

I have an FX Crown I purchased new in May 2018, SN FXC 181098. I am interested in doing some upgrades for increasing power for shooting slugs. I've looked at several components for doing this, such as Huma Regulator, hammer weights, Huma pellet probe and hammer springs. It seems inorder to...

I have a 45 minute SCBA tank with a 40 inch microbore hose. Once the guns tank is filled and the SCBA valve is closed and the valve to take the air pressure out of the micro hose is opened there is a lot of wasted air. If I had a 20 inch microbore hose instead, would there be much savings of...

I have an FX Crown MKI in .25 cal with an STX 600mm Superior liner installed. I've been shooting with fair success NSA 33.5 and 36.2 grain slugs. I'm tuned now at 135 bar, hammer 5 and getting about 820 fps. I'm not interested in purchasing another rifle, but wouldn't mind spending the extra...

I read a reply back from NSA on a previous post on lubing NSA slugs, where they said they tumble slugs after forming, then sonic clean, and finally tumble again with silicon lube. Yesterday I went to try out for the first time a box of .25 cal. 36.2 grain slugs. I was shooting them straight...

I installed a 600mm FX Superior liner for my .25 cal. Crown last summer, and started trying slugs for the first time. I've only shot NSA slugs and FX Hybrid. I bought the NSA variety pack to try different weights, and finally settled with the 33.5 grain for their grouping. My question is, do...

I've had my .25 cal Crown for some time now and have tuned it with various H&N pellets and JSB MKII and Kings. I have only used the number side of the wheel, but I've noticed there may need to be a finer hammer spring adjustment to get the best tune, so I want to include the Letter side of...

My previous pcp I had settled on H & N Match to be the most accurate pellet. I was washing and lubing those pellets, and would find many small pieces of lead slag in the bottom of the pot after washing, so I really considered washing a good thing. Now I am shooting an FX Crown and I'm shooting...

I have not seen this mentioned before, and maybe I'm trying to do something that isn't possible, but I have been trying to fill up a Crown magazine that had only been partially emptied when I removed it from my rifle. The only way I have figured out to fill the magazine is by emptying all the...

I have a new scope that came with free mounts that I put on my FX Crown today and I can't get the reticles adjusted to the target. I'm shooting at 50 yds, and right now with my turret bottomed out on up, I am still 2 mil low. My L/R turret is adjusted with about 3/4ths of its adjustment to the...

I'm trying to make a decision on buying the FX Streamline .25 cal or the FX Wildcat MK II .25 cal. I've never had a bullpup before, but the bottom line for me is accuracy at 50+ yds. I will do most of my shooting off a bi pod. The Smooth Twist X liner I believe is very new, and I haven't...

I'm ready to upgrade my scope for a new FX rifle. After doing some research, I've narrowed it down to two Hawke models The specifications are very similar, so I would like to know what the differences are. the first model is a Hawke Airmax 4-12X40 AO, and the next one is a Hawke Panorama...

I have a Hatsan AT 44 QE .22 cal. that I have been shooting since last summer. After experimenting with many different pellets, I came to the conclusion that H&N Baracuda Match 21.14 g @ 5.53 head size gave me the best accuracy. I do almost all my shooting from a bi pod bench rest at 50 yds. ...

I'm ready to do an upgrade in my PCP rifle, and I've narrowed it down to the new FX Wildcat MKII in .25 cal. While doing my research on this rifle, I found three places on line that sells it, and they are all the same price at $1299.99. My only dilemma is that they all list a different barrel...

I have had my first SCBA tank and hose assembly for only a few months now. I have been recharging my rifle after shooting about 10 shots each time. There seems like there is a lot of wasted air in the micro-bore hose each time the bleeder is opened. The hose assembly I have is 40" long, which...

I'm fairly new in the air gun world to understanding the relationship in velocity of different caliber and weights of pellets and how they effect accuracy. I've only owned my first PCP air rifle for 3 months where it is possible to change the hammer spring pressure, which will effect velocity. ...

I've just recently got my first air tank set up. I have a used SCBA 45 minute carbon tank and hose assembly from AirTanksForSale. I have a local scuba shop that has did my first fill for me. This set up fills my gun fine, but the first question I have is that once the gun is filled, and tank...

From the factory received setting of the hammer spring adjustment, is there a limit on safety or effectiveness on the number of turns the screw the screw should be turned to increase or decrease spring pressure? What are the number of turns can we normally expect to go? Lamar