Search results for query: *

What is exactly the problem? Can you move the handle and tension the spring? Or the hammer doesn't lock in position? If first remove the left side on the cocking mechanism and examine the point of failure. Second remove the richt side cover and check if the trigger mechanism is holding the...

Exactly. If that not solves your problem, you can cut one ring of your spring. Then grind the spring nice and flat. Then sand the surface smooth. Last scot & bright. Wash the spring clean with break cleaner. Installing with grease.

So you can try this. Open the backside and take a look at the spring. Sometimes the spring is not fitting the adjuster wheel. Because of the space between hammer and valve. The reason is hammer bounce. The spring can go wrong on the adjuster. You can solve this by squeeze the spring slightly...

The Prophet is amazing. I like the design and minimalism. The cocking can be better. I have made a video about the mechanism improvements. The pelletpusher has a bolt with an iron bush. When cocking that bush rounds the corner before going down. Also when shooting minimal movement backwards. In...

80 bar with no ristriction

I have noticed after shooting a lot with the .177. Use 10 Grain or higher. No need for restrictor. The heavier knockout slugs 13Gr work better, then the 10Gr.

50.15Grain KnockOut slugs

You are right. Also the pellet pusher wears on the block. That wil result in a $500,- replacement. Or you have to work on the gun. That will lead to the question. Would I buy it again? Maybe. I did choose the prophet instead of the Impact M3. The barrel of the M3 is not that good. Lots...

I have received the new 4-gen valve. A little disappointing looking at the quality finish. Polished, looking like this: After shooting I have noticed the gun consumes a lot more air. The valve is closing slower. The hole is 0.9mm. The older valve has 1.5mm.

The same thing I have experienced. The transferport is scraping lead. Removing the sharp edges is time consuming, because of the shape. I also made the inlet of the barrel a little bigger. Ending up with a good polish. Now the bullets go in nice and smooth. If you want a high-quality finish PCP...

I have made this. A bush from teflon. Let you guys the experience know.

On 15 March 2023 Matias said. In about six months we'll start having .30 barrels with the same inlets as the .22. I think the .177 also. Shooting with the .177 knockout slugs at 100 bar is also allready good, in my experience. I did not polisch the .22 barrel yet. With the Knockout slugs it is...

I have two ideas. Turning a new bush and bold a little smaller with teflon around. Or when the wear is bigger. Milling a screw down insert piece.

You can buy the barrel here: https://luchtbuks.com/nl/rti-prophet-rpb-barrel-55mm-60cm

RTI is also gonna sell the .177 and .30 as RPB. -1, if you have one. That would be great if these are one of most accurate pellet and slug barrels.

check this video. The video explains to pick a good slug for your barrel.

I have shot the prophet 2 for a while. .177, .22 and .30. I have noticed wear on the locking mechanism. Below is a photo. Does anyone has the same wear, with the RTI? There is even a little play.

Do you have a picture of the crown for me? Simon

RTI wil soon receive a batch new valves. When they arrive, I will get one.

After how many shots? I did around 500 shots. Also 60 shots .30 full power. 50.15GR 147 Joules.