Search results for query: *

Nice Work. This is my version of the 3d printed action cam mount. the action camera can be replaced by a phone just by removing it and sliding in a phone mount.

66 Yes

I am still working on the design, there is always a room for improvements. @Smok3y - This why I made it retractable, to fit different lengths. I am also working on different type of clamps to fit different bottles and with different types of rails. on my impact I have the long arca rail...

I designed it and 3d printed it myself.

I am using this adjustable length 3d printed rail

Nice shooting and amazing groups Michael. Looking at your velocity that you can reach, I am very surprised, cause the max mine can reach is 933 fps, no matter what settings I adjust in the programmer. I think my RW is in trouble. And even the accuracy is not consistent. if I fill the gun above...

Hi Hookster, you mentioned you are reaching 1000 fps with the JSB redesigned. is it with the factory settings or you programmed it ?. the max mine can reach is 933 fps, no matter what settings are dialed into the programmer. and the velocity is not stable. it goes from 917 to 933 fps.

you can reduce the magazine spring tension by removing the screw holding the magazine cover and letting the spring roll 1 turn counter clockwise. you should be careful when doing this, so the spring won't jump in all directions.

Hi, here is a detailed diagram about the reg o rings

Hi, Most probably you should replace the upper o ring in the regulator adjuster. if this one is leaking, air would pass directly through the delrin valve.


it is custom made, and the height adjustment screw goes all the way along the length of it. when used in standing position, it gives the rifle a nice balance toward the back

Hi Guys, this is what I use

Hi, Finally the leak from the venting hole is solved thanks to Ernest. I managed to replace the mysterious C-39 o-ring successfully and reinstalled the regulator in place. I also did some shooting over the chrony and everything looks good. Thank you Ernest Regards

Dear Ernest, Thank you for your reply, unfortunately our authorized dealer is not qualified at all, and we have no choice but doing the repair ourselves thanks to your effort and guidelines. Now that you mentioned that the o-ring is there, I will try replacing it and hopefully I will succeed...

Hi Everyone, My FX Impact has been leaking from the atmospheric venting hole since the first day I got it. the leak is sometime not noticeable and some other times it goes crazy. However if I remove the air cylinder the regulator holds the air forever. I did a drawing of the regulator inside the...

In this diagram, picture C, the O ring labeled C-39 is not there for real. I took out my reg and didn't find it. The O-ring causing the leak from the vent hole was the C-35.

Thank you Ernest for your great support. the leak was from the gauge and it just needed to be tightened.

Dear Ernest, in my case, which is a slow leak, I am trying to analyse the situation before I take the gun apart. if I take the bottle off, the reg will hold the air in the regulated chamber with no drop. what is your opinion on that ? today I started with the easy things first. I took off the...

Mine is only a month old and it is also leaking. it is losing around 40 bar in 24 hours. It is a slow leak and so far I couldn't find out from where is the leak. I noticed that if I take the bottle off, the regulator holds the air in the regulated chamber without any drop. Unfortunately we don't...

Reading all of this, makes me wonder how does it work when it comes to FX impact ? since the power knob controls the hammer spring tension. And add to it the valve opening. lots and lots of possibilities and calculations.