Search results for query: *

I have shot the 124 and RX2 in .177 both with adjustable B square mounts , replaced the seal in the 124 and I have repaired the mount on the RX2, the 124 is shooting nice groups at 25 yards with H&N FTT 8.64 grain. 750 fps. RX2 not shooting that good with H&N Barracuda heavy,s a little...

Made the stop pin and now installed hecoil inserts in the gimbals 2 were striped, I think this will be better then original threads, as the set screws will be pushing on the coils. Think the mount will hold up to the RX2,

I have welded a smaller one and turned it down. this could snap or break if it dose I will try the brass bushing Thanks for the info.

The RX2 has a larger scope stop hole then most guns, does any one know of a scope mount with a stop pin that will fill the scope stop hole in the receiver, I would prefer no slop. Looks like about 242 thousands I know its metric.

I have read that if you apply spring tar to the safety it stops the safety issue, I just purchased a used one from AOA ser # 12400507 and it dose have feinwerkbau on bottom side of the barrel near the stock, it dosent look like its been apart looks new, no safety issue but its not smooth its...