Search results for query: *

I too tried Steve initially for my Izzy, but he was too busy to promise anything so I went with Rink. It went very well and he even made a change to my spec that he thought would suit me better. My personal suggestion (from experience) for Rink is to register and use their automated progress...

Thanks for the reply. Mine actually cracked into two pieces, and the trigger still functions, so I always wondered what it did.

Try inserting a layer/s of paper to take up the clearance and add friction, enough to a point where it's takes a bit of force to slide it on. It's reversible and doesn't harm anything.

Shane over at AoA. Excellent service!

Anyone know what that half round shaped piece just forward of the trigger blade does? It's attached by a pin and fine spring.

H&N Finale Match Lights for me.

I use a couple of 3/16" thick sheet rubber scraps in my trap (mine are approximately 8" x 10" to fit the trap), with the back plate being steel. I found that if I let them hang loosely, attached/hung by binder clips (or whatever) they absorb impacts and deaden the sound quite a bit. The first...

maxtrouble: Went the same route for my Baikal and I hope that I don't run into the same problems, but I know what to expect if I do. Thanks for the heads-up!

Mine works well with Finale Match Lights.

I used an old 70's/80's Samsonite briefcase that I just happened to have saved. I gutted it, lined with felt material and used 1" thick foam (the harder white stuff) with the profile cut out. It fits diagonally. Every time I shoot it, I get to tell my wife "I'll be in my office".

@ Crowski- That is how mine (factory seal) looked as well. Replaced with the Vortek PG 4 kit and am very happy with it so far. My spring was also in pieces.

maxtrouble: Thanks for the info, that's very helpful!

I purchased a 46M from Canada Shooting Supply (thanks to the forum members for the heads up!), excellent service and fast shipping. Very happy with it.

Great channel! I echo everyone's sentiments. I'm subbed.

Thanks for the tip! Ordered a set yesterday.

Tinbum sells a baffle kit, but looks like he's out.

I have a .22 HW97 and put a DonnyFL Tanto on it for the same reasons as jimoak. I purchased the thread adapter from AOA. It's short enough (barely) to fit in my plastic case without taking it off. It just looks a little funky as the Tanto has a matte finish with machined flats, but I don't mind it.

I have the same issue. There was a link to a bunch of free targets on this site but I can't find it anymore. I found one that had a thick black border around the bullseye, but it was white in the center. That one helped me the most because I could see the hits (barely) as well as the bull in...

Those stocks are beautiful!

My HW97KT likes H&N FTT 5.55. It's a tight fit, but works for me.