Search results for query: *

I strongly suggest you avoid any and all Firearms powder or pneumatic until you attend training classes.

The compressor output is very small so you probably have a leak on the Gold filter assembly. Soap and water will help you track it down.

There is no math. Having been many times to China for industrial Hydraulic system startups I can assure you they have ZERO mill certificates for the materials they use. These disks are made in gross, batch tested and are at best case +/- 10% accurate for rupture worse yet the repeatability is a...

Ok. Your 1 st photo shows drive motor and crank housing. To the right is the high pressure head and output. 1st thing to try is with unit off open the bleed valve, plug output hose with dead head plug...should have got one with the unit, turn system on and slowly close bleed valve. On a working...

Judging by the sound made when coming to a stop, my belief is there is likely and overcurrent draw with the motor and the motor on board protection shut it down. When this occurs, if you immediately vented the pressure and restarted would it re-engage immediately? If not, how much time passes...

Should display continuously. Replaced my batteries after 2 years of use. Mine used AG23 1.5 volt batteries 2 pcs.

Are you certain they are flared fittings or are they compression type?

I believe in the Black Box control is an overload relay that is wired into the reset circuit. You may need to take apart to get at it but thus could cause the shutdown prematurely.

It is possible the reset button itself is faulty and improperly sensing overcurrent shutting down the circuit. There are other items that can also cause a premature shutdown. I hope Tuxing provide good guidance 🙏 not my experience. If you know a good electrical tech, he can monitor current draw...

You most definitely have a leak. Make a soapy water solution and spray each connection. I would start with hose/deadhead and work up to pressure gage. Good luck.

Depends on the hour meter you purchase. Here is an example off ebay. You would need your volt meter to find a switched on power source of appropriate voltage off the board.

I have the version that includes the coolant tank, pump and radiator. I have been using it for over 2 years. Fixed various leaks and use Seco 500 oil. Very pleased with it's performance.

I could not have said it better. I did large industrial startups in China before I retired and can assure you their QC is non existent. Many items are passed thru without ever reaching test specs. Attorneys in China except for governmental purposes are almost non existent while here they consume...

The reason is the law of diminishing returns.

Just remove the entire assembly and replace with proper size M10 or M8 etc fitting with male quick connect on Both the filter and block. Then buy a proper length hose with female quick connects. Future maintenance of filter you only need to remove quick connect.

Very true. Jumsted indicated this air out the breather was New situation since changing seals and not raising pressure..that's why "in general "..

In general, if air comes out the filler/breather, it indicates blowby of the piston. Rings/seals and cylinder bore in need of inspection.

When you start getting into pressure exceeding 5000psi you quickly approach specialized fittings, tubes, and materials requiring Autofrettage process to insure design pressure safety.I can forsee very dangerous results for the consumer with Zero legal recourse. Regulation and certification will...

This listing has been renewed

This listing has been renewed