Search results for query: *

Hello …question anybody knows the size of the two screws on the barrel clamp ….feedback would be appreciated

got these today in .22 and .30 imeadetely I loaded up the .30 with 43.8 NSA slugs and they were moving around just as much as the FX plastic version then I loaded up the 50 gr JSB pellets they hold snug....don't think that these will solve the problem of smaller projectiles from shifting but...

grabbed this from a Alkin dealer yesterday for 300 1/4 NTP in and out gonna add it to my Omega standard compressor or my booster pump

There's six holes where the mag sits where it looks like they all should have rubber balls i think that my Impact only had 1 or 2 so I order a couple extra with some parts I needed now my mag has less play in it and I haven't had any misfed slugs so far....when I 1st installed them they kept...

do you think that it still needs a mostiure filter ?

does anybody know how to tell the difference between the gen 5 and gen 6 may buy on soon and don't wanna get one that was left over from 2019 and seller is just saying that its the 2020 version 

does anybody know where to purchase the needle/pin style pellet probe 

Does anybody know what size is the o-ring at the end or the valvepin ...checked the Schematics sheet and its listed as one piece and o-ring size is not listed ....and the durometer also 

Does anybody know if the barrel/caliber are interchangeable.....22 cal.HPS will be next on my list and would like to be able to switch out to .30 cal. If possible....if not the .22 HPS will do just fine And also gun is expensive so how much would a caliber change kit run me.....

Are the barrels suppose to have two o-rings inside the liner lock/ jam nut ...

tion between GQ and you. DELETE heavyw8 Sent right now Star hello fellow Impact owners..I seen you post on ordering bulk orings from oringsandmore.com and was hoping that you could help me out with a couple of questions….which orings are the right ones to order is it "Buna metric" when i...

[email protected] .. Has anyone used this custom power plenum for .30 cal.....if so how much of an increase did you get ....and if you had any problems with it 

is that right the new Impacts MKII with power plenum don't have a rubber ball behind the valve adjuster 

any good tips on how to disassemble fixed shroud without damaging it, do you unloosin both sides, what tools to use ......etc.

does anybody know what all has to be changed to use CF bottle with texan 257 and what increased shot count to expect 

does anybody know the size of the 3 orings that go around the barrel/pellet liner ......and are they different sizes for different calibers