Search results for query: *

Hi all fixed my burst disk with a brass shim cut out with scissor's and an oring and its holding fine.. also is was on 8.5 FPE added 2 shims and got me to 10.5FPE and one more shim put me bang on 12FPE with JSB hades. So that 3 X 0.25mm Shims - So i might drop one more in and see what I get?

also is it possible to get a manometer in the burst disk thread - this would show us the reg pressure?

try it on 1,2,3 settings down from Max - FPS might go up!!!

sounds like the hammer cant open the valve past 100bar, he will need to use the high power spring and heaviest hammer weight. its a balancing act between the force of the hammer hitting the valve open and on higher reg pressure you need more force to open it.

awesome

How do you measure the Regulator Bar?

has anyone figured out the twist rate on the 22 pcp virtus?

heres mine on 8FPE its got 13 bellvilles and 2 flat washers? I assume you I refers to the silver flat washers?

just got mine - whats the advice? Mine is doing 8FPE so if I add a couple of washers will the power go up or will it go down if the hammer cant open the valve enough?

great thanks I was hoping for 26mm but that'll do FYI its for my wildcat Mk3 to Wildcat BT conversion (without cutting the stock down). I needed to make up 380mm for the bottle adapter to clear the fore end. and with my 700mm barrel the 480 CC comes up with just enough clearance for the...

I dont have one to hand and would like to know the length added by 1 dreamline power plenum? can someone measure it up for me?

has anyone switched from V1 to V2 TP and seen any benefits?

it has this massive alloy air stripper inside - so I fitted the end cap back on ( left the stripper out) and it does go on my 30 700 but even if I ignore that its 9cm short - I would still have to drill out the end cap as its from a .177 and the exit hole is 5.5mm! so I think ii will sell it...

Yes the heavier hammer weight will open the valve for longer and allow more air to escape so this will help your slugs - but for pellets just dial the power down

Ive ended up with a "standard" "500mm barrel" shroud for the impact - its the one where the barrel only goes about half way in. ends up making a 500 barrel looking like a 700!! Is there anyway I can modify the internals so that I can use it on my 700mm barrels?

Its an easy problem to solve - Sadly I didnt do a video or Photos when I fitted mine - but I am doing 2 more 1X mk2 and 1X Mk3 in the next few weeks - so I will do at least photos or a video then. but see if you can picture this: 1 insert the allen bolt from the left hand side 2 insert a...

Last week My Impact dumped its air through as the valve wasn't closing properly so I stripped it down cleaned and lubed it all up and put it back together yesterday and boom its fixed - holds air and fires fire ( to it from 240 to 200 with the usual 4 shots) only issue is that the cocking...

1725.45

Mine died yesterday. after about 10 hours of use,, so check yours now. Windage from dialled right in to right out there are 31 clicks but only the first 20 move the reticle the last 11 do nothing Elevation is the same from bottomed out the reticle moves for the first 21 clicks then stays put...