Search results for query: *

Sure does! Thanks very much Matt!

I've seen some guys use these for field target. Magnetic closure at the top. Sort silicone stretches when you reach in. Not sure what your looking for but this may be a good option.

Pellet seating depth. Make sure the most common pellets seat fully into the rifling. I have seen problems with this on Daystate rifles(Redwolf) and again recently on the BRK Ghost.

Thanks Franklink

Thanks very much! Really appreciated.

I don't suspect Rc4fun was talking about me when he said he's dissapointed there are no answers yet. By all means if you have the sizes. Please share. I use. 22 and .25 cal. I suspect most of the o rings are the same aside from the breech/probe which is caliber specific.

I agree it's an option but I don't want to reverse engineer orings from a source which probably took measurements from in use/pre installed orings which may have already taken a set. The guns been out long enough I was hoping someone has already been down this path. I'll share what I find...

.22 and .25

Does anyone have a list of o-ring sizes for the BRK ghost? All I can find on their website is the exploded view diagram. It calls the o rings out by number but has no corresponding size references. I know there are "kits" available with all the o-rings, but I'd like to buy my own and...

You're right. I think the issue with that .30 was insufficient seating depth with the factory probe. I just want motivated to screw with it anymore. The .30 uses a lot of air.

I really wanted to love that .30 ghost setup. I just couldn't get tight groups past 50y. 50 and under were one hole. It honestly surprised me because that factory barrel was flawless.

I completely agree. I've had very few great barrels. I've had many "just ok" and unfortunately more than a couple bad ones. If you have a good one, I wouldn't mess with it.

It's a rifled, 1:17, choked barrel. I don't plan to shoot slugs on this one. I considered the poly barrel but figured I'd start with what I'm familiar with first. I do plan on getting a polygonal barrel now to see which one is more accurate.

Thanks a lot. I completely agree. I was holding my breath on those shots hoping they'd group. Really excited now that I know I can rebarrel a rifle if it doesn't meet the bar right out-of the box. On the FX guns $100 for a new liner isn't a big deal but for a Daystate or Brk etc where a new...

Quick write up on the first shots/accuracy is here: https://www.airgunnation.com/threads/22-ghost-lw-barrel-blank-first-test.1307049/

Quick write up on the first shots/accuracy is here: https://www.airgunnation.com/threads/22-ghost-lw-barrel-blank-first-test.1307049/

Quick write up on the first shots/accuracy is here: https://www.airgunnation.com/threads/22-ghost-lw-barrel-blank-first-test.1307049/

I had a chance to install the freshly cut barrel and probe into my Ghost. Since it was last tuned for .30 pellets, I turned the power wheel (hammer) down from 12->7. I was so excited to see what it would do, I didnt bother breaking out the chrony. I just loaded up some JSB redesigns and let...

Good advice. I did switch to HSS at the end but found the finish wasnt a whole lot better; so I went back to the carbide. The reason for the spider with 2 sets of bolts is to bring the barrel into concentricity along two points. With a 4 jaw, the bore can be dialed in on one point. For...

While Im waiting on a 304 stainless rod to arrive, I roughed out a trial probe in aluminum. Im experimenting a bit with the probe length. The factory BRK Ghost .30 probe didnt seat the pellet fully into the rifling. To test, I loaded the pellet using the barrel/probe installed in the gun...