Search results for query: *

OK so i shoot target pistol at home and have baikal 46m and tau 7. The Tau 7 being co2 makes a hell of a crack, i like the luxury of shooting when i want, 7 am sunday morning and all and of course have neighbours. So i set about making a silencer because this type of gun is shot single handed it...

In the interest of weight reduction i have gone to a two position adjustment, takes about 100 grams from the weight. now adjusted on the hinges.

Think its done. So after the first effort i tried to use aluminium for the series of interlocking plates instead of the steel, the upshot is the aluminium binds too much when the pressure is of the joints. So stuck with the steel and a weight of 505 Grams bit of a let down. However i managed to...

So i posted a hamster design recently for the Kral. Have redesigned so that there is a single point of adjustment, a large single wing nut pressures to 12mm bars onto the hinges locking the hole thing in place. I can now adjust rapidly with the rifle still shouldered, and allows individual angle...

I built an adjustable butt plate for my Kral puncher breaker so needed a hamster for the fore end. I had two criteria, low weight, i managed to keep it under 250 grams and a low profile when fully closed, it closes at 45mm. Its constructed out of aluminium, two 15mm u section have four hollow...

Made out of picatinny rail with the slots removed + 4 camera mounts and two metal butt plates. originally made in brass but two heavy re made in aluminium. Additional holes have been drilled in the metal butt plate to allow 10mm of horizontal adjustment both right and left. Have one photo below...

found shouldering this rifle a real pain in the neck, had to stoop my neck to get a good sight picture. So i came up with this DIY remedy. Used two camera mounts a filed down scope rail and a couple of brass plates to make an adjustable butt pad. The pad hold rock solid and i now shoot from a...