Search results for query: *

Maybe try a luminary scope, mine has 5 adjustment on red or green, which thickens the crosshairs just a hair each click

Thanks for all the responses, I pulled it apart again today And rechecked valve it was good. I went ahead and pulled the pump cup(new) and it didn’t feel as snug as when I put it in so I used the hair dryer and glass boulder marble trick all is well now. Tomorrow I will take it out back and c...

Johnl yea I tried cocking it, left bolt pulled back and air come out the load area. Slid bolt shut(without pellet) and air continued out end of barrel. Wondering if maybe I missed an oring for exhaust port? I think the Sheridan’s from my dads era incorporated a tiny oring between the air tube...

Ok so I.rebuilt the valve with all new stock parts, I replaced pump cup. The pump cup fits snug but when I go to pump it the air blows out the end with the slide bolt closed(has new oring). The air tube is clean and clear of any dings/scratches. And valve has few light scratches but nothing...

I may end up doing this since tearing it down a week ago I’ve found the housing (receiver) has broken stud for air tube, bb load cover is missing then there is the broken barrel mount which is on the GOOD receiver side so I have weak points on both sides that i need to address, all that and a...

So the teeth will be on inside diameter of barrel? And the new mount will have said teeth on its outer? 

Thank you for the pic, after browsing through the Crosman archives it’s hard to see differences the one obvious difference in your collection is the darker brown one. I found a barrel mount for mine(plastic) for 3 bucks, and a whole new barrel, mount, and rear sight for 19 bucks. Do you no what...

Thank you do you know why it is labeled as a model D? I’m hoping it don’t stand for degenerate there’s a lot of plastic the barrel mount is plastic and broke on one side. Well thanks again for your help

I have a pumpmaster the model is 760 D. I can’t find anything about this model, s/n is 896102054. Is this built in 1996, August? Has plastic stock And absolutely no sights on the barrel there is a plastic barrel mount with a broken pin. On other models this is part number760 074, anyone no...

I apologize for not getting back to my post, life throws stuff at you here and there ya know? Yes my rifle looks a lot like the picture posted, just not as shiny. I got a seal kit for my pump master so I figure if I can get that back in working condition then I will take a shot at the Sheridan...

Hey everyone, I’m wondering what the cost is roughly aside from to and fro shipping to get the seals done on a C9A 22. ? I’ve never opened one up and I don’t have the special tools listed in the manual. I’m not so much worried bout the cost(reasonable in mind) as I am screwing it up. It has...

so im looking for some literature with detailed instruction on replacing the seals on my Benjamin? It’s 22 cal “C9A” the serial shows October 2001. And where I can order the kit? It looks a little tricky but there seems to be a wealth of information in here. Any good advice on the project is...

just joined here wanted to say hello I have a ruger 177 break barrel single shot pellet,a Crosman 09A series 22 caliber multi pump single shot pellet, Crosman pump master 760 bb/pellet, an APX bb/pellet multi pump, and a couple of compound bows which are great for bass fishing the California...