Search results for query: *

Why not make a tube "barrel" like the FX Verminator uses? Get a tube about the size of a standard arrow's I.D. and solder it onto a fitting that fits the Talon. Put an O-ring on the muzzle end to seal the gap if needed. There's probably a patent involved so don't try to sell them.

This is just an observation on the Daystate 110. When I was shopping for a compressor I looked at all the options. I noticed that Coltri dealers don't advertise or in some cases sell the 110 volt version that Daystate has. Also the Daystate 110 only has 3 stages of compression. The 220 volt...

I would think that it would be better at stabilizing them than a slow twist pellet barrel. Especially if you shot 35-45 grain slugs in it.

We use a shelf life of 2 years at work. That's from the cure date (when they were made) not when we got them. Air and UV cause them to deteriorate. They are not returnable because there is no way for the vender to know how old they are. Some of our customers require seals that are less than 6...

Viton(fleurocarbon) seals are mainly for high temperature applications. Urethane is preferred for higher pressures. Nitrile (buna) kind of splits the difference and is the general purpose choice for most applications. The higher the durometer the harder the compound it is made from. There...

Bullet molds for the .41 action express cartridges are .410" diameter. They would easily resize to .408" diameter. Cast .41 bullets may be available online as I believe they are also for a .41 Magnum. Most pre-cast bullets are lubed however.

480.87

Take a piece of steel about a half inch thick. Drill a little shorter than the length of your pellet with a pellet size drill. Then drill thru the rest of the way with your hollow point diameter. It should follow center from the larger diameter point and be close to center when you turn it over...

I was going to buy a Streamline but they disappeared from the stores. I was then going to buy a Dreamline but after a few months of waiting with none available I gave that up. I liked the wildcat but it didn't look especially left hand friendly. Same with a lot of other air guns. For something...

I have a set of Fowler digital calipers that I've used for years. I was a machinist for a while a few years back.

For me the most important thing would be how it works for a left hander. AEAC Steve could do a bit better on this as well.

Sorry I didn't get this in the correct forum.

I finally decided to join the PCP ranks. After a couple of months of research and indecision I bought a 22 Vulcan 2 from Talon tunes The service was very good and it arrived intact. The gun seems very well built with a very good trigger. It holds air unlike my initial hatsan purchase. The test...

Coltri has some very good videos on YouTube. I watched them before ordering my mch-6.

Halfway between Chicago and Indianapolis

If you are interested I just purchased a MCH-6 from the Florida distributor for $2779 with an hour meter installed. Delivery is extra. They have them on sale for phone orders.