Search results for query: *

Hi just bought a new rifle .22 cal fitted a huma extended rail and 2 plenums can’t wait to shoot it Sunday. Does anyone have a good reg pressure for pellets and slugs?

Hi does anyone know where I can get a replacement fill port for a fx impact m3 my female foster fitting no Longer connects to it

Hi just received my barrel holder from Saudi Arabia does anyone know what torque sequence it should be? I’m worried I will over tighten and crack barrel my rifle is an fx impact m3 here’s s pic on how much I have tighten the clamp

I’m thinking about deleting my first reg by turning it up as far as it will go can someone tell me if this will stop the first 3 shots being low in fps.

Looks like sekhmet have improved 100% on their customer service. Nicole Rai is the new chief executive and she certainly knows how to Look after customer's well.

Hi does anyone know what size socket or spanner the reg guage takes.the 27 mm doesn’t seem to grip well. I want to install the digital guage and I’m finding it hard to get off

Does anyone have a good tune for a fx impact m3 700 mm barrel using .22 22 grain hybrid slugs I just need good starting point.

Hi I change 2 orings in the my Dreamline and its still leaking through the vent hole is it possible the reg is leaking through vent hole.

Hi any one know how to get this off it seems to be on tight

Hi I have just installed a new huma reg guage for the Dreamline tactical I changed the factory oring and replaced with the supplied oring now it’s leaking through the guage does anyone know what’s going on? It came with a small and large oring ring I have tried both and they both leak would it...

Hi everytime I take my Dreamline tactical out to the range my first shot is Around 812 fps then second goes back to 870 fps the reg is on around 110 And it stays consistent so could someone tell me what the problem might be this is a pic it’s the newer version with the power plenum

Hi my lower picatiny rail on my brocock sniper hr has cracked where can I buy a replacement. here’s pics. This one looks different to the one in the brocock site would it still fit?

Hi just wondering if I need a special scope to use the olight odin glm for my fx impact m3.Will I still be able to sight it in with the athlon midas tac? 

Hi does anyone know if the grub screw was missing on the cocking lever on their fx impact m3 which holds the pin in when they bought their rifle. I think they forget to put mine in at the factory because the pin was protruding upwards after my range shoot on Sunday.

Hi can anyone recommend a good Quality pellet weigher.

Hi do I need to change the transfer port to use fx hybrid 22 grain slugs or can I shoot without moving barrel around also does anyone have any good tunes.

Hi just bought a 12 litre 300 bar faber scuba tank with a best fittings 300bar din adapter I have previously used a hills hand pump so I'm new to using a scuba tank. The best fittings adapter has a flow restricter so could someone tell me how fast the air will come out when I open the valve. My...

Hi does anyone know how to stack the belleville washers on my huma reg I have 9 washers in total I have the reg set at 120 bar.

Hi how do adjust hammerspring on my brocock hr sniper it seems to have a different configuration than most snipers. Also is it ok to remove anti tamper sticker to increase regulater preasure.

Hi could someone tell me why you have to adjust hammer spring when your adjusting regulater to make your rifle shoot more accurately. I'm a bit confused I understand the reason for adjusting regulater but not hammer spring also does anyone know the best way to do it.