Search results for query: *

Fact 1. took money from my bank 1/05/21 ( $48 for 1 set of o-rings for fx crown) 2.printed label sent tracking number.1/12/21 3.still not shipped as of.10am 1/21/21 i am no doctor or a marine but i am p---ed!!

i read some where if you peck on your gauges (under load) & they change they are bad...true or false??

what do i need to fill the bottle off of the gun?? (spare) tks 

now after 10 min.on hold,,,they say email or leave message then hang up....just to let everyone know....

what is the difference in the air flow,they look about the same??

i can not seem to find the (3) dowel pin part numbers that hold the trigger in.anyone see them on the drawing???? thanks

how exactly do the belleville washers work,(in a fx impact or crown)?? 

anyone come up with a way to test the fx impact & crown regs.out of the gun?? i would like to buy one....tks

fast shipping,,,,over-nite,, less than 10 bucks!!!! $8.09 

can you buy the fx crown amp reg washers? tks

anyone know what the screw is for under the reg.gauge,,small grub screw in the center.(i took it out to clean bore) & now my reg.gauge will not show psi???

ordered new huma reg.@11:01 am today..jeff marked shipped @ 11:10 today......great job.

anyone know how many o-rings are inside a huma gen3- fx crown amp reg...tks.

is there away to change the shot count? it starts over at 10,i would like for it to go to 18.(my mag size)????

why do they come with a new one from the factory?? 

fast shipping (with in 2hrs.) fx crown 22 side shot mag.works great!!! $49.99...plus 2nd day air for less than 10 bucks..........can not beat that!!! tks.

anyone know if d41 has changed,,bottom one is out of my gun,top is from revised drawing- en.19.01 dated 2019-08-26.no o-ring,, white plastic piece or brass bushing in drawing??called fxusa & emailed with no response at all.. s/n 1821xx thanks .

i have several 10mm belleville washers that are different heights,(.002 - .005) does anyone know if that would effect or cause inconsistent fps.? have both fx & huma. i have it below 10 but looking better..tks.

the new fx crowns d29 o-ring has changed to a 10x1.5 & so has d30 to a 7.5x2 (per newman @ fx) if you use the d29- 9x1.5 (per fx crown parts list) you may damage your reg.as i did..... hope this helps somebody...

should the fiber rings on top of brass piston need to lubed when replaced? thanks