Search results for query: *

This listing has been renewed

This listing has been renewed

This listing has been renewed

This listing has been renewed

This listing has been renewed

That is awesome job. Very smart idea.

This listing has been renewed

This listing has been renewed

I have 5 - 13 shot magazines for it. The aftermarket magazines are much better made than the OEM It has an internal moderator in front of the muzzle inside the shroud, and it has an external moderator that screws on to the shroud, both made by Murphy. You can see that the inside of the stock...

Thank you Brian!

Has anyone seen or know where to down load a exploded diagram for the 1358? I would like to change out the hammer spring but I am a little leery of just unscrewing the power adjustment bolt not knowing what else is behind the screw.

Great, thank you. The hammer bounce is loud when your ear is close to the source.

Great thank you for the reply. Any idea where to get a shorter hammer spring? I will hunt around for the post here. Thank you again

I just picked up one of these rifles myself, couldn't pass up a 22 caliber PCP rifle for $215 on Amazon. I will be doing to of the easy mods, first the trigger return spring. Second shorten the op-rod by removing a few threads off the trigger end to shorten the first stage. Have you gotten rid...

You do beautiful work

Where did you get the wood grips? I have 2 - 78G and a 79G.

There are a few great tutorials on YouTube. It comes apart pretty easily. the only problem can be removing the power pin sleeve. It has to come out before the top and bottom hale can be separated. When you purchase the new seal kit, get nylon ones and get the one with the new value stem and save...

So I push the stem towards the seal, it will come out and than I can put a new flat seal into the cup side. So the stem pinches the seal and some what holds the seal in place. I am going to take them apart, and see what happens. I would gladly pay you for the new seals, if you can make them...

I believe I can get them apart, but I have a question, which way do I push the shaft out? I have 3 of them. I have seen JG airguns on Ebay offer a rebuild kit with the plunger, but it is shorter, and appears to have a nylon head. They also had the "exchange" program on their site.

I am looking to purchase 3 exhaust valves for S&W 76Gs, I found one source that will exchange refurbished one for your old ones. But read that the customer service is very poor., and I do not want to lose the valves I have, because of poor communication. Anyone have a source for these valves? Mark