Search results for query: *

Just got my new Tuxing TXED012 compressor today. Spent the morning getting it set up and settled in. I can get more shots per fill now. Before, I would not take more than 20 shots because all I had was a hand pump and I hated spending an hour topping off my rifles. Having that compressor is...

I was wondering how much second reg pressure the stock fx impact m3 hammer and spring can efficiently handle?

I have an Impact M3 with a huma regulator. I have a slow leak between the reg. and the gun body. Takes about 4 days to leak down from 250 bar to 230 bar. I can find no charts, diagrams or tables that give o-ring sizes. I suspect the manufacturer wants you to buy their rebuild kits instead of...

I had a couple of 1" scope rings laying in my junk drawer and came up with this.. I had no carbon fiber tube's so I used pvc pipe and zip ties. Setup has no contact with barrel.

I have a situation that I can't figure out. I have an FX Impact m3 in .25 cal with a 700 mm barrel. I have installed a Huma slug power kit with the 6.9 gram hammer and 1st and 2nd stage Huma regulators. 1st reg...........170 2nd reg..........140 Macro.............1...

My M3 will not hold preasure. I hook it up to my compressor and all of the air comes out the tiny hole behind the safety. Is the second stage reg. the only thing that that vents through that hole?

Yesterday while plinking I started getting extreme variation of fps. I noticed the Guage on 1st reg would pop back to 180, settle at 170, slowly sink to 140, stay there a few seconds and then repeat the whole thing. After a few cycles it would settle on 150 and stay there until the next shot...