Search results for query: *

Would someone who has a phone number for Neil call him and let him know that his email has been hijacked I just got an email from him asking if I would purchase a gift card for a good friends birthday who has liver cancer. He said in the email that he is traveling right now so he can't buy...

Would someone who has a phone number for Neil call him and let him know that his email has been hijacked I just got an email from him asking if I would purchase a gift card for a good friends birthday who has liver cancer. He said in the email that he is traveling right now so he can't buy...

NO LONGER NEEDED If you bought a new FX .22 crown continuum with the new lite barrel system and the new superior pellet liner and you only want the 380mm barrel on your crown, I want to buy your 700mm barrel. I'm not looking for a "caliber change kit" with a probe, just the 700mm lite...

Can you use one of the booster pumps like the shoebox with low pressure nitrogen? 6,000psi nitrogen is impossible to get in my area.

Title says it

Anyone know where you can purchase these in the U.S. ? And, no, they aren't mints. They are "O rings/gaskets" used to seal a PCP gauge for instance. They are used in the newer Kral punchers to seal the gauge. It is Kral part number AT 26 and Kral calls it a manometer O Ring but it isn't...

I've seen this question popping up on here since about 2017 but I still haven't found where anyone has answered it. Does anyone in the world (outside or inside of Turkey) know the sizes of the orings used in the Kral puncher airguns????? I'm mainly concerned with the oring in the valve...

I get a small puff of air in my face each time it fires a pellet. The air is coming from the opening in the rear of the block directly beneath the end of the cocking lever. I've single loaded a pellet and put a small piece of tp over the pellet probe and it doesn't move when the airgun fires...

Anyone know anything about this company? They make pellet/slug dies/sizers. They have videos on YT but no way to contact them.

Who is a moderator for airgunnation?

I finally got a chance to look at this scope and compare it to three others I have. I still have not had a chance to put it to the test on the range and I currently don't have any way to take decent pictures looking through the scopes so I could show the differences. I'm working on that but...

I want either a short or long Continuum 22 barrel. Message me what you have and what price you're looking to get for it.

Assuming you can reach the same velocities either way when tuning, is it better to have higher reg pressure with less hammer spring or lower reg pressure with more hammer spring?? I'm working with my new 22 Avenger now and when It arrived from the factory the reg was set at 3,000 and the hammer...

I received my Avenger this week and just an early assessment but it seems to live up to the hype. It would be nice to know what they adjust it to before it leaves the factory because it has pretty high velocities for all pellets. At this point all I'm doing with it is trying to establish a...

Well., I just finished registering for EBR 2020. We'll see how things evolve between now and October. 

told him I wanted to buy the scope yesterday at 10:30pm and got this email back from him at 11pm. Sent paypal this morning and money was immediately refunded with the explanation that "someone else bought it in the middle of the night". that's the internet for you. It's yours when...

No longer looking

Looking at the failures of a lot of the compressors, I'm wondering if anyone has looked at modifying the crank bearing to improve reliability? My first YH blew a rod and made a hole in the case. I think I can repair the hole and rebuild it but the way the bearing is made still is a concern.

How do I know if my RW 22 HP has the ART barrel or not?

Looking for RW Walnut stock.