Search results for query: *

One aperture is probably larger than the other. You can open up the smaller of the 2 with an appropriate drill bit.

@crowski Try an adjustable iris eyepiece the first chance that you get to try one! It sounds like the aperture is too small for your eyes in one of your eye pieces. You can gauge them both and see if there is a difference, and open up the smaller of the two with an appropriately sized drill...

Tom Strayhorn had that rifle on his table at the Findlay show one year. He had a large display of choice rifles from his Walther collection laid out for the public. I have secretly lusted after that very rifle for years, and you are quite the fortunate soul to be it's caretaker! A tip of...

Gehmann says to run it through an ultrasonic bath. https://www.targettalk.org/viewtopic.php?t=50299

The add on scope rail makes me think HW85/R10.

Disassemble the rifle down to the firing valve seal and replace it as described above. The original Anschutz seals used in these rifles are known to deform over time and will seize the firing valve in place, or cause drag on the valve that affects the velocity and operation. I suspect that...

There is a part available from Walther that is a modified cocking lever for scope mounting. The part number is - 2610230

Custom Stocks of Sheffield make left handed Prosport stocks.

I am going to attempt to get both of these examples up and functioning.

First sentence Used an airgun, a type of firearm......... Journalism degrees usually convey that one has an understanding of the language, correct? No minimum science requirement for a journalism degree? Do 'journalists' even require a degree anymore?

Get out on that jetty and throw some bait.

This thread should get pinned as a classifieds sales picture posting primer for new members. Yes, I would love to purchase your revolver! Lifetime ban, you degenerate

Not really that easy all the time

I do not think that you are on solid footing with this post......

The info I spoke of earlier has apparently vanished along with the forum where it was posted...... An new OEM FWB piston ring measures .036 in thickness. FWB recommends they be changed out at a certain wear point as it wil allow the rings end gap to increase, allowing more blow by and lower...

My vote goes to the ring sealing the compression cylinder. I will have to search it out, but FWB calls out the piston ring dimension, and mandate replacement at a point. I will pop back with info bits when I can track them down.

You are welcome. If I can be of further service, do not hesitate to reach out.

That is a good looking rifle, it certainly did not spend its life as a club mule.

No problem, I think that you will be pleased. I forget the guys name that makes those, but I do believe that he is active on some airgun forums, possibly the American Vintage Airguns forum.

Comparison photo for you