Search results for query: *

From time to time I have had a spot of trouble with gauges that has been rectified simply by degassing the gun and removing the inspect the seal. Twice now I have found that during an overhaul and reassembly I have over-tightened the gauge resulting in the seal squishing flat and blocking the...

So weird. I buy US scopes and optics and have them shipped to my US address, then go pick them up and have no issues coming across a land border into Canada. The only thing I was told (by the US side) was that I couldn't bring any heat sensing optics home. The Cdn side said no problem.

Toyota Corolla? Nah. Volvo 240!!!

I discovered a primo bell ringing piece today. I was in the shop and my eye fell upon a bent mower blade in the rubbish bucket. Its about 24 inches. I drilled a hole at the edge of the middle of the blade, just above the center bolt hole, and attached a free fitting clip. Man, does that thing...

Every day for the past couple of years. I don't think I am getting any better though....

You may be right about the OEM tank and valve being locked; I just can't get them separated. I will have a look and see if I can find a CF tank of similar size that I can use. What a pain. I have a few pressure vessels, like paint ball tanks, but they are all too short. The original tank is 12...

What is the trick to removing the tank valve on a spinloc tank? I got a Huben regulator I want to install, and darned if I can get the tank valve to budge. Thanks, JD

Off a waterbed?? That's crazy!!

Fish in a barrel.....

We were emailing back and forth a couple of days ago. He's working flat out I think. Give him a day or so to respond; its a one man operation. The website is fine.

I think your hands are too clean to be working on airguns. :giggle:

Do people not understand how tariffs work?? When your government slaps tariffs on items, it is not the foreign seller that pays the tarrifs, it is the buyer in the USA that pays it. Ihear of so many people that seem to think that because the tariffs are applied to foreign countires that it is...

Thanks for the replies, and forgive me for momentarily thinking that Brocock was American. I knew better, but had a brain seize I guess. So, 1/2 inch UNF, thank you.

I've recently got a Brocock Concept in .22 cal. I'm trying to find an air stripper to fit, but don't know what the threads are on the muzzle. They appear to be M12 X 1.0, but can that be right on and American made rifle?

Turns out I was trying to adjust the incorrect fitting. I did not see the correct brass fitting which is located under the trigger guard. Wes corrected me, and all is well.

Mine was the same way. I read and re-read the scanty instructions, and it seems that, after dumping all the air through the bleed valve, the regulator adjustment is already bottomed out, thus I cannot adjust it any lower than 210bar. I was hoping to lower the reg a bit. I emailed Wes, just...

Thanks. Its a real odd ball isn't it.

Did you get a moderator for yours? If so, could you take a picture of it where is is attached to the shroud? I got mine today as well, but am wondering if there is an adapter I could use to mount an air stripper.

Thanks, I guess I will be tearing into it then.

I notice there is a lot of blowby that hits my cheek while shooting this rifle, coming from the magazine/breech. Is that common with this rifle, or should I be delving into the innards looking for a bad o-ring? cheers JD