Search results for query: *

You need a ninja regulator seal kit for that ninja regulator. No I didn’t do a video, sorry.

If unit is down for too long, rust can build up on low pressure side by the reeds. Unhook tube that takes low pressure air to hi pressure side. Check if you can stop air flow from low pressure side with finger. If the reed plates are rusted shut on low pressure side, hi pressure will not build...

Umarex Hammer is a .510. Before I raised output pressure on regulator, manual said it could shoot 350 gr. @ 850. When I first shot it, 350gr read 860 on chronograph. ✌️

When you replace rings, run it for 10 minutes so the seals seat properly without pressure. You should also use a little silicone oil on rings before installing hi pressure head. Clean the carbon off the disk in the picture above (12.3)

New design uses 3 hi pressure rings

I've been using Mobil RARUS 427. Works great, doesn't build up too much carbon, and the air or purged water doesn't smell like ass. LOL

I got the challenger 3-18 x50 when 704 had a discount code lasts year. I think it’s excellent for the $. Surprising clear glass, holds zero, tracks great and has 20mil of elevation. Hard to be for the $

You can use a laser to assist you zeroing. Put a mark on target that laser will always point to. Take a shot, while maintaining laser on mark you first made. Keep laser pointed and mark, and move crosshairs to bullet hole. Done 😁

lol I read 3 -14L tanks . I thought, what tank is 14L 😂

JB weld should fix that. No real water pressure builds up. If that doesn’t work, I may have an old head in my garage I could send you.

👆This. The compressor should be on a 20A breaker. When it trips a 20A breaker now, and didn’t do it before, the problem is not in the breaker. The compressor is telling you it’s overloaded, and time to find out why. Common reason for tripping 20A is water getting into second stage (water doesn’t...

https://a.co/d/5g3UyRg That small round disk, gets carbon build up after a while. If too much builds up it, will diesel (Detonate) . When that occurs, the temperature goes up faster that usual, and hotter than usual. It will also destroy the hi pressure rings on hi pressure piston.

take hi pressure head off and check seals, and also check the round check valve on hi pressure cylinder head. Too much carbon buildup cause detonation, and can trip breaker. Clean or replace. Kits on Amazon are inexpensive

https://a.co/d/cgzFjo6 seal kit works on many compressors. It may have the seals you need

Check the safety on the stock. You have to screw out enough to see a red seal. Or put it aside, and put back when done shooting

Agreed. Nothing beats a good wire nut. 😁

it also depends what hi pressure head you have.

clean your check valves. Make sure water is not sneaking in to hi pressure side. Probably a bad seal, and water is building up in hiprssure cylinder

maybe if it’s a ton of water. The pump starts and gets to 3000 psi. A ton of water if everything is tq correctly, the piston rod (the one that’s attached to the motor axle) should break before popping either compression head

gasket on plate if just a tiny bit nicked, you get small amount of water in line going to hi pressure side, and it will stop pump. After a tiny bit of water gets out, it will pump again, until it builds up again. The amount of water needed to stop the pump is tiny. If check seal gets stuck, it...