Search results for query: *

https://huggettmoderators.com/partners/ For further information, contact [email protected]

If you follow this link, does Krale state they cannot deliver to the US? https://www.krale.shop/nl/geluiddemper-huggett-astille/

Nick, the devil is in the details. You may be able to get a quieter mod that does not do odd things to your system. Can you post a picture of the problem stup? Does the stock mod look like this? What does the attachment look like? Male or female thread. Diameter / pitch?

The pellet path is curved. You have to crank in elevation to hit the 40 yard target. Perhaps the new moderator is heavy and pulling the barrel muzzle down. More sight elevation is required to fix that. The elevation change induced at 40 yards is 40/15 x the required correction at 15 yards...

That a moderator can cause such low shooting at 15 yards and high shooting at 25 yards does not compute. Something is being bumped in between. The barrel or the sights. Without changing the sights, put the old mod back on and try again. If the new mod was clipping I would expect large...

Can't post them on forum - new rules. Email works. Will PM you details.

The above version has a functional shroud. More useful and flexible options.

Sending PM

The lack of sensitivity to distorted pellets in that video at 10 meter is impressive. Now do that again at 25 and 50 yards, with round nose pellets...

I don't mind you deviating from the subject of the thread. I object to you you correcting someone asking a question that is on topic. You seemed to be playing forum police, so I thought you might like to see what it is like. :)

Your brain is fine. See my reply directly above.

In that case, why does the thread link contain "airmaks-moderator-vs-huma.1311925"?

STO likes to follow up a series of TVs with hair curlers in a 2:1 length ratio. Hair curlers take the edge off, but something has to do the bulk of the work before that for more potent PCPs. Either a TV or very large volume both work for that. For less potent PCPs in relation to the size of...

Replace the stock insert with a longer one that protrudes past the stock casing. A guy like Graycrait can help you make the selection. Several people can supply the insert, such as Firewalker or TorqueMaster. All it takes is driving out two pins, replacing the stock insert and putting the...

All barrels are not equal. Lothar Walther barrels have larger land and groove diameters than other airgun barrels. Some barrels are heavily choked and others not at all. So, Nervoustrigger's suggestion above, to wrap a slightly undersized rod with tape to create a custom fit in your barrel...

PM sent to LayeredOgre.

The flat recessed crown shown above does offer some protection to the bore edge from accidental bumps. Valuable, for unshrouded barrels that will be used without any form of protection, such as a moderator.

The deeper and more acute the crown angle, the more critical that the crown be coaxial with the barrel bore. Also the more obvious if the barrel bore is not concentric to the OD. Else, due to the low muzzle pressure of typical airguns crowns, anything from flat to 60 degree included angle...

I would expect more of a velocity increase, if the starting length was "short". Unless the plenum were very small, and the valve duration very short. Could be a ,mispositioned O-ring at the breech thimble, leaking air. Put the original short barrel back in to see if you got the original...

The new barrel may have higher bore friction. Shoot it some more and see if it improves. If your tune is mild the last few inches of barrel may not add much anyway. Especially if your reg pressure is high and the valve dwell very short. Then the average air pressure driving the pellet is...