Reply To: Picitinny/Weaver Rails on a P-Rod?

Forums PCP Airguns Picitinny/Weaver Rails on a P-Rod? Reply To: Picitinny/Weaver Rails on a P-Rod?

Link

ztirffritz
Participant
Member

OK, I contacted R Arms Innovations and they sent me some rails to try to do this.  I was able to make it work, but I had to trim one of the rails to fit on the bottom.  I also had to go to the hardware store to get some longer screws and nuts.  The end result though is that, yes, you can put picitinny rails on the p-rod stock with some very minor modifications.

What I started with: 

The bottom rail was too long.  I trimmed it with a hacksaw and then filed it smooth at the end and colored it with a Sharpie.

Here is the inside of the stock:

This is where I drilled holes and mounted the side rails:

After the bottom rail was cut down it was almost exactly the same length as the side rails.

I bought a UTG bi-pod and it mounts nicely on the bottom rail:

I think it came out looking pretty cool