Reply To: Trouble trying to hold hammer to adjust spring tension…hatsan 44-10

Forums PCP Airguns Trouble trying to hold hammer to adjust spring tension…hatsan 44-10 Reply To: Trouble trying to hold hammer to adjust spring tension…hatsan 44-10

Link

Rocko
Participant
Member

I saw in your previous post you drilled your hole in the bottom of your stock. There is a small hole in the side of the hammer that your wrench has to fit into to keep it from turning.  Either your drilled hole doesn’t line up with the hole in the hammer or your wrench is to big.  Remove stock if you have to & look into the hole while turning the adjuster wrench until you can see it line up. The adjuster wrench is 4mm & has to be long enough to reach.  I had to cut a wrench in half & weld an extension in the middle to make one long enough.