Reply To: Tuning my new P-rod

Forums PCP Airguns Tuning my new P-rod Reply To: Tuning my new P-rod

Link

Hepotter
Participant
Member

Dear Wretch…

I reamed out several ports in the Prod, used a heavier spring, and although your shot count will likely go down a bit, you might find a heavier pellet will do better with accuracy.  I was shooting 21 gr JSB's and had no accuracy problems.  You can always dial the hammer spring back if too much power becomes a problem…unlikely, but anything is possible.

I ended up shooting slugs, because that Prod can be brought up to short carbine performance.  It's a "sleeper"…do a little reading on Prod performance.  You might end up putting a buttstock on it.

 

Regards,

Kindly 'Ol Uncle