Reply To: My low power pellet design MK1

Forums Pellets, Projectiles, Slugs, & Ammo My low power pellet design MK1 Reply To: My low power pellet design MK1

Link

pinballjon
Participant
Member

Take a piece of steel about a half inch thick.  Drill a little shorter than the length of your pellet with a pellet size drill. Then drill thru the rest of the way with your hollow point diameter. It should follow center from the larger diameter point and be close to center when you turn it over and use it as a guide bushing. Using a drill press would be preferable. I used to make hollow point bullets like this.