Reply To: Fx wildcat Help

Forums PCP Airguns Fx wildcat Help Reply To: Fx wildcat Help

Link

Crusher
Participant
Member

The help sheet says 
“Check that the measurement from the side of the breechblock to the end part of the feeding pin is between 28,55-28,8 – if its incorrect release the 2 stop screws at the reload sliding bracket, then push the feedingpin in to the correct length and then tighten the screws while holding the feedingpin in the correct position.”

Could someone post a picture showing what they mean by: “2 stop screws of the reload sliding bracket”.  I want to check mine and if it is out, set it correctly. Also, preparing to take the gun apart to install the red and I know it is going to move.

Also, +1 to Smokin for the good info. I would never have seen this.

Crusher