Reply To: Eagle Vision Infinity FAE-S50 scope mounts question

Forums Optics, Scopes, Rings, & Mounts Eagle Vision Infinity FAE-S50 scope mounts question Reply To: Eagle Vision Infinity FAE-S50 scope mounts question

Link

Brian10956
Participant
Member

I don’t have this mount but after looking at it on line I would try the following first I would look into the hole on the “finger screw” to see if there is a set screw that is tightened down in there. If not I would use a small socket wrench to loosen the finger screw after backing the set screw out a bit if it’s there . I would also check with the manufacturer in England for instructions if your not sure how to adjust that type of site. Typically the front ring is kept in its lower position slightly loose(but tight on the rail) and the rear ring is raised up and tighten in a elevated position, then tighten front mount,  this will allow the scope to be adjusted to keep cross hairs on target at longer distances. This mount is similar to the FX ring which I have used.