Reply To: Regulator Installation & Results – Air Arms S510 (Pictures)

Forums PCP Airguns Regulator Installation & Results – Air Arms S510 (Pictures) Reply To: Regulator Installation & Results – Air Arms S510 (Pictures)

Link

Matt_Dubber
Participant
Member

“Cookie”Am rather interested in graph results.

Have you re-tested pellet speed consistency to see whether variances are still same?

Did you shorten the valve return spring before re-inserting into the brass housing (pot) you shortened? If so, by how much?

Do you know the diameter of the hole in the end (nearest regulator) of the shortened brass housing (air intake of pot)?


Hi Cookie

-I haven’t re-tested anything yet. These were my initial results, but I plan to re-test once I’ve put a few hundred shots through the gun.
-I didn’t shorten the valve return spring at all. The pot was cut behind the spring retaining step and I left the spring exactly how it was. 
-I don’t know the exact diameter of the hole in the pot, but I’m guessing it was probably around 7-10mm – Very large.

Matt