Reply To: Regulator Installation & Results – Air Arms S510 (Pictures)

Forums PCP Airguns Regulator Installation & Results – Air Arms S510 (Pictures) Reply To: Regulator Installation & Results – Air Arms S510 (Pictures)

Link

Cookie
Participant
Member

In order to install a Lane regulator you normally just need a hand drill, though sometimes (such as with S510) a couple of basic tools anyone would have in their garage. You don’t need a drill press or lathe.

The regulators are marked with notches and you are given a guide as to where to set it with a screwdriver, though Rob uses the general ideal setting for your calibre/power level. Each person, depending upon their requirements, can fine tune it to maximise efficiency etc. Lots of sheets/guidance given, and an encyclopaedic knowledge and helpful expert is on the other end of the phone….Rob Lane.

 http://airgunregulators.com/

Lots of helpful and surprising videos on YouTube.

https://www.youtube.com/channel/UC3KOGhoz0WhwcfparNN9CRA