Reply To: ALIGN PROBE WITH TRANSFER PORT, IMPACT

Forums PCP Airguns ALIGN PROBE WITH TRANSFER PORT, IMPACT Reply To: ALIGN PROBE WITH TRANSFER PORT, IMPACT

Link

Gumby31
Participant
Member

i don’t have it in mm but 44.3 is (according to you) is just on the edge of lining up but if i convert it to inches seams way to far 1.744. As not to confuse things this is the way i did mine. not saying there isn’t another way. The pellet probe lined up in the barrel on my gun is .604. measure from edge of brass to inside shoulder of pellet probe. Off the gun.
Now put the probe and barrel back on the gun take off back cheek rest and remove one side of the shoulder stock measure where you did before with the bolt closed of corse.
you can convert my # to mm but i would use your own mic and your own # 
probe out to far  .609…….15.4684mm
probe in to far    .599…….15.2146mm
sweet spot         .604…….15.3416mm
Now if it is off you got to take the gun apart. Ernest videos can show you that  hope this helps