I replaced the hammer part#19039(not the hammer weight) because I had knackerd it up decocking the gun while trying to set the trigger. However with the new hammer the trigger sear will still not catch. Does anyone have a vid or tips for putting the trigger sear back together? I'm 99.9 sure I've put it back together correctly multiple times but that sear will still not catch on the hammer when I cock it back.
FX FX Wildcat mk3 BT Trigger Sear Not Catching on Hammer.
- Thread starter Air-15
- Start date
May I suggest a You Tube search for Ernest Rowe videos
You may find something there.
Also search 910 AIrguns for videos as well
just my 2 frames/sec
Edward
You may find something there.
Also search 910 AIrguns for videos as well
just my 2 frames/sec
Edward
Upvote 0
Thank you for the reply, I think I just got it.
I don't think the hammer was being pulled back far enough, I messed with readjusting the two grub screws that the cocking lever attaches to and was able to get the sear to start locking to the hammer.
Upvote 0
Something I found with my Wildcat MK3 causing cocking issues was over torquing the stock screws. It seems my stock, if over tightened, would cause a binding on the rear parts of the trigger and not allow the sear to engage. For now I have loosened the two stock screws but a couple of shims are being considered.
Upvote 0
You will likely need to totally readjust the trigger since the hammer is slightly different.
Upvote 0