is this one semi auto? price? how many shots per fill at say around 600 fps?
you can PM me if you want to..
Mark
Upvote 0
Tequila Gun PCP
- Thread starter Xolotl
- Start date
you can PM me if you want to..
Mark
Probably could, except the pellet would pretty much fall out of the end of the muzzle IMHO. I've shot my .22 out to 50 yards, ok, "lobbed" is more accurate. Even managed to hit a 4" gong....eventually. You're only going to get so much air out of that short barrel and have it work well.
Upvote 0
FINALLY got my Tequila out, it'd been quite a while, worked with some garbage 18gr, 580 fps and some 15.3(??) 650 fps, then set up my reactive at 25 yards. Using my red dot which means I can barely see anything and a rest, hit the 4" then the 2" then spun the 1", actually did that a few times. Both pellets had essentially the same POA/POI. Got about 25 shot/fill. Now to get the trigger under 1#, if it's even possible, I've had it down to 1# 12.3oz.
Upvote 0
And....Now I've got a seal leak again, I have to find the write up I did here on AGN on how to fix it, I have the pictures but I never made a copy for my garbage records. It's an easy fix just don't want to reinvent the wheel. It's post #203 pg 11 btw, I added some stuff to the writeup for clarification and how to get to the regulator.
Gun is reassembled thanks to my AWESOME write up and having those pesky 0-rings. It holds air, now....back to hitting that 1" target at 25 yards.
Gun is reassembled thanks to my AWESOME write up and having those pesky 0-rings. It holds air, now....back to hitting that 1" target at 25 yards.
Last edited:
Upvote 0
This one is aluminum 3D printed . I decided add honeycomb pattern to reduce weight and cost.
Upvote 0
You could sleeve it with a pre-cut foam.
What’s the length of pull?
Is it a Picatinny/1913 mounting?
Moreover, what’s the tube size and does it have the same outside diameter as the honeycomb section’s?
Thanks
Upvote 0
You could sleeve it with a pre-cut foam.
What’s the length of pull? 14 inches
Is it a Picatinny/1913 mounting? There are to types one picatinny and other for the TequilaGUN it is mounting removing the beaver tail.
Moreover, what’s the tube size and does it have the same outside diameter as the honeycomb section’s? The diameter of the carbon fiber tube and honeycomb 3D printer part is 3/4”.
Thanks
Upvote 0