You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Huma Reg Vulcan 3
- Thread starter SHOTGUNSTAN6969
- Start date
I have shot the 30gr with my vulcan 500 laser accurate 170 bar will get the 30gr going around 930 fps you will need a heavier spring you can use talontune spring
I have done a lot of tests on the Vulcan factory regulator and the Huma The factory regulator is amazing and very consistent build like a tank, but If you go above 170 bar It will become slower you may need to change the washer stacking it will fix this problem and make it recover faster Right now my v500 shooting JSB 18.13gr and the v700 shooting the 33gr precision slug amazing rifles and they will draw a smile on your face whenever you use them
I have done a lot of tests on the Vulcan factory regulator and the Huma The factory regulator is amazing and very consistent build like a tank, but If you go above 170 bar It will become slower you may need to change the washer stacking it will fix this problem and make it recover faster Right now my v500 shooting JSB 18.13gr and the v700 shooting the 33gr precision slug amazing rifles and they will draw a smile on your face whenever you use them
Upvote 0
Tryed to order a talontune spring online but keept saying somthing about my postcode mabe cos I'm from UK. Best I can get is a fx mk2 spring which done the job when I put my agt reg at just over 170 bar. Yes your right I had to turn it back down. It shot well for a few days an then went off the ball not sure y. That y I'm giving the huma reg a go. I got 2 agt regs so might have a play with 1 of the stacks. Any info on a stack. What I did notice with the agt reg in a tester. Anything 150 an under it would stop in the tester where it should. Then anything over 150 it would go past... release a bit of air an then it would go to what the reg was set at. Do that mean it's creeping. Omg av u see them hp regs lol monsters never seen them before until I came across 1 on hereI have shot the 30gr with my vulcan 500 laser accurate 170 bar will get the 30gr going around 930 fps you will need a heavier spring you can use talontune spring
I have done a lot of tests on the Vulcan factory regulator and the Huma The factory regulator is amazing and very consistent build like a tank, but If you go above 170 bar It will become slower you may need to change the washer stacking it will fix this problem and make it recover faster Right now my v500 shooting JSB 18.13gr and the v700 shooting the 33gr precision slug amazing rifles and they will draw a smile on your face whenever you use them
Upvote 0