Added cheap CVLife picatinny bipod, Monstrum adjustable picatinny scope rings and 3-12x Bugbuster scope. Used and removed a piece of cardstock to shim rings up in the back. Have to wait till weekend to shoot it.
The french forums mention a 2 week old free 3d print "M12x1.75mm" accessory on cults3d with no feedback yet.
Fit and finish and general feel is beyond the bullpup T-rex. The rail is split and I can only mount the bugbuster is one spot on the rail but it seems to be in a good spot, although it might be too far forward for some. The buttstock has an adjustment screw for cheek height but it seems you'll just rip out the heatset insert if you try to lock it at the highest position. I will get a shorter bolt to try instead of cranking it down.
Other forums mention 3 or so setscrews that need to be adjusted in unison or else they might snap, and that the sears are rounded off to prevent hair triggers. The Lancer Sp500 Pistol had trigger adjustment changes so I dunno until I open it but the T-Rex Bullpup adjustments were consistent with previous offerings.
The french forums mention a 2 week old free 3d print "M12x1.75mm" accessory on cults3d with no feedback yet.
Fit and finish and general feel is beyond the bullpup T-rex. The rail is split and I can only mount the bugbuster is one spot on the rail but it seems to be in a good spot, although it might be too far forward for some. The buttstock has an adjustment screw for cheek height but it seems you'll just rip out the heatset insert if you try to lock it at the highest position. I will get a shorter bolt to try instead of cranking it down.
Other forums mention 3 or so setscrews that need to be adjusted in unison or else they might snap, and that the sears are rounded off to prevent hair triggers. The Lancer Sp500 Pistol had trigger adjustment changes so I dunno until I open it but the T-Rex Bullpup adjustments were consistent with previous offerings.
