I use either a GX cs4i or Tuxing txedm 042.
I go to 5000 psi with both
the Tuxing was only $360 delivered
Upvote 0
Huben Huben GK1 arrival day🍻
- Thread starter Gongetit
- Start date
I go to 5000 psi with both
the Tuxing was only $360 delivered
Nice. I have been eyeing the cs4 but since this seems to be doing the job for now, I am going to wait as long as I can. Also appreciate the heads up on the tuxing. 
Upvote 0
Try opening the power knob close to full and then let us know if using gk1 without suppressor does not require ear gear.
Upvote 0
If you’ve got a question I would rather you asked me on a open forum, the answer might be handy for another member
Upvote 0
I have a Ataman AP16 and want to buy new O-rings...Bagnall&Kirkwood sells them but they don't ship to Belgium because of new regulations.Perhaps you can help me out?If you’ve got a question I would rather you asked me on a open forum, the answer might be handy for another member
Upvote 0
we were discussing what to condition the walnut grips with a few posts back. I am happy to report 100% tung oil is the way to go. My steps-
1. Rub a single light coat
2. Let absorb for 20mins
3. Wipe excess off.
4. 0000 steel wool to smooth between coats if you need more. 1 coat was enough for me. It popped the grain and dries to a nice flat finish.
1. Rub a single light coat
2. Let absorb for 20mins
3. Wipe excess off.
4. 0000 steel wool to smooth between coats if you need more. 1 coat was enough for me. It popped the grain and dries to a nice flat finish.
Last edited:
Upvote 0
You did not do any pretreatment, such as steel wool ? Just straight up wiped the grip with Tung oil? Looks beautiful.
Upvote 0