Hey
I just got a great deal on the 1357 for about $200.
Have been reading around, and I would like to add a suppressor and a bipod.
But the parts I found for both threading and rail is 3d printed. Anyone have any experience with that? I am a bit wary when it's not steel.
I would also like to add a regulator, but not sure if it's smart yet. Seen conflicting debates about it.
And is there any potential to make this a semi hard hitting gun with some more mods? As I already have a very precise plinker gun.
This is most likely going to take down some birds. So would be nice to have some power with ok groups.
I just got a great deal on the 1357 for about $200.
Have been reading around, and I would like to add a suppressor and a bipod.
But the parts I found for both threading and rail is 3d printed. Anyone have any experience with that? I am a bit wary when it's not steel.
I would also like to add a regulator, but not sure if it's smart yet. Seen conflicting debates about it.
And is there any potential to make this a semi hard hitting gun with some more mods? As I already have a very precise plinker gun.
This is most likely going to take down some birds. So would be nice to have some power with ok groups.