Somehow, l managed to lose the washer under the front trigger guard mount, that spaces it to let the bear trap device move freely. I have a lathe but don't know the deminsion of the washer. Anyone know the diameter and thickness of this washer? Thanks for any help. Don
HW97 help please!
- Thread starter doninva
- Start date
It isn’t just a washer. It is a flanged spacer. You can get one from Chambers Air Gun Spares in the UK in probably less than a week. You can find them an order on line.
Upvote 0
Measure the width of the hole area the washer fits/ washer od , the screw/bolt hole size , then the gap space /clearance thickness you need.. cut the new washer and fit it .
Upvote 0
Thanks guys, Pyramyd wanted 9.99 plus shipping and Chambers wanted 4.85 pounds plus shipping. I whipped one up, out of a scape rod, in about 10 minutes. No shipping required 
. Thanks again, Don
. Thanks again, DonUpvote 0