Recent content by Zesty

I believe they advise not to place the magnets on the side of the compressor that houses the electronics.

It would seem to me that proper lubricants and lubrication methods would be a very useful and essential bit of information. From the first paragraph of your first post in this thread: "The point of this thread is to have a repository of information for all things concerning the GK1 so that...

There is/was? a .25cal Hatsan AT44 in the classifieds for $200 that would do the trick. They are pretty bombproof in my experience.

Try soaking rags in ammonia and placing them under your deck. It worked for me!

This AT44 has the "H" cylinder, and I fill to right about 150 bar.

Thanks for the headsup stovepipe, much appreciated! I have no doubt the bipod is the real deal....I got it from Primary Arms for like $300 so it better be real!!! hahaha

Haha sorry misunderstood, I was shooting from a table using a front bag with the gun shouldered. At that speed when you hit the can it rips a big hole in them, so it's hard to tell exactly where the pellet impacts. Did not miss a shot from 10ys! LOL I will check out accuracy on paper and with...

My reg is right about 130 bar, and this is with the power wheel at absolute lowest setting.

I only shot cans full of water from about 10yds, so I would not be the best to comment on accuracy potential at that power. I must correct myself just checked my notes and it was actually 300fps on lowest setting!

With reg @ about 130 bar with 18g JSB, power wheel on lowest, my Huben shoots right around 350fps.

Sorry l guess you answered that! They can pull more power than a blackbird? Is it because the blackbird mag draws power? Thank you!

Why did you not like the blackbird? It is more limited than the bumblebee?

would you part with them?

I got it boys thank you so very much!!! I was just being overly cautious, had to twist that sucker more than I thought. Appreciate the help gentlemen!!!

Pardon me for reviving an older thread, but I also have 1 of these. Bought from Drozdmax who modified it to 600/900/1200rpm with F/A. Drozdmax also did a BB alignment mod to the mag, and I bought the Jim C barrel kit. Does anybody know if the barrels are still available? I shot out my stock...