ZeroVibe's latest activity

I’ve been down the o ring rabbit hole as well. Of the several assortments of o rings I’ve purchased I don’t think any actually fit the...

I’ve purchased several O-ring kits over the years. They’re great for having a wide variety of O-ring sizes except the one I need.

Shot the JSB Exact King’s in 25.39 this morning. I’ve found them a bit more inconsistent than the FX. POA is a little different as well.

Hello Nation, I'm looking for an o'ring set that will help keep my rifles up and going. I am aware that there are vendors that sell...

I had made years ago a SKIRT straightening tool that was made to make skirts round again without making them flared out or larger in...

Ok, I thought about what ZeroVibe said about our targets getting obnoxious. I only have 2 rifles and my basement to shoot in. Currently...

I agree with @UDABEGGER, it sounds like a barrel indexing issue.

As to your shift to the right goes I think you need to index your barrel . I have been there and done it with my M4 22 SNIPER !

I've used the Sonus and the DonnyFL SUMO with good results

My posts are probably really getting old so go ahead and post away! 😁

Just shot my daily paper. I figure since I do this every day, this thread may get obnoxious with my posts of the same bit. I’ll post...

I'm sure mileage varies, just cuddle it and sing it a lullaby 🤣

Just did another sheet prone, only using minimum magnification (4x). I did up using illumination, I simply couldn’t make out crosshairs...

Positional shooting from a tank trap, approximately 19 yards. Once I broke the shot, I immediately move to a different position but no...

My current pellet consumption borders on the absurd as far as I'm concerned. Though I think I found two different brands of 25.39...