Recent content by xsarfc9x

Did some more testing with my M60B in .22. after adjusting the probe length and trying a couple different LDCs, I'm going to settle on the .217 JSB KOs. I get consistent MOA at 100m and got a decent 5 shot group at 200m today. Bit of a south crosswind so should tighten up a bit when calmer. Fx...

A few years back I did the same thing and it sold on eBay after sitting for four months. I felt bad and included a decent scope, pellets and a few other extras.

😂 Probably listed it so he could tell the wife he's trying to sell it.

13.5mm, your right. I had posted the OD but having a case of the Monday today.

That's the HST. You can adjust it without taking the bracket off. Just loosen the adjustable shoulder bit and you can adjust it. It doesn't take much force to adjust. Barrels are a smaller OD so cant swap between Zelos barrels :(. I was hoping they would be. Upside though, the 13mm barrels are...

Nice video, you should post it on the Zelos FB page as well. How you liking it in .25?

Maybe the sent us the Zelos 2 😂

I'm with ya on being a little underwhelmed. I think the first batch they made a mistake with the transfer ports. As I said in the other thread the barrel TP is 4mm which is small. If it gets opened up I'm sure it'll put out more power. The hammer weight is heavier then the Zelos and it's got...

I'm getting 70fpe with the 35g cast peanut slugs but at 210 bar. The 4mm barrel TP is anemic. I didn't get to the valve but I'm assuming it wasn't opened up enough. Seems like they got all the other things you'd need to do to make big power but neglected to open the ports up.

Did a partial tear down today since I was getting some binding at the end of the cocking stroke. I ended up adjusting the bolt probe forward a turn and it's binds less and the bolt probe sits more flush with the barrel TP * hat tip to Steve on the Zelos FB page. Some things I noticed in the...

Got back to the range today. Tested the reg from 140 bar up to 210 with the Jav .218 30g and worked thru the hammer spring adjustments which don't seem make much adjustments in speed. 140bar 620-650 150 bar 840-860 170 bar 850-880 180 bar 880-912 190 bar 905-920 210 bar 930-960 Tested a couple...

I got to the range this morning and did some testing. Didnt have enough time to thoroughly test it but got some results. Seems to like .218 sized slugs better then .217. Only shot at 100m and best slugs were the .218 26g Javelins, .218 H&N 30g and .218 28g Zans. All were about 1.5MOA. I didn't...

Ratzy on the other max1 thread posted this Shroud thread is m28x1 Donny AeA Models A83 for 1/2-20 A91 for M18x1 When I bought mine at Alamo AG the packaging just said AEA Challenger. Didn't have a model #. I think I got the .357 version because the hole measures just a big bigger then that...

Packaging didn't have a part number but it was labeled as Donny FL Challenger adapter which should be A91. I went by Alamo AG and tested a few and the Challenger labeled one worked.

For the end cap, I bought an AEA 1/2" adapter and it threaded in and works to add a moderator. Worked thru hammer spring adjustments and got 967 max on the 190bar setting with 30g slugs