Recent content by Will74

I Don't know what to say. No it's not. Lol. Just because some dimwit does it, doesn't mean that's what is supposed to be done. Do yourselves a favor and check the measurements. The original plenum is something like 2 inches long. XL maybe 3 inches and XXL 4 inches. They are meant to be...

I believe Huma manufactures everything in the house. It's not a big thing for them to make sure it's right. Your new part will be on its way anytime now. Their moral compass is spot on. An unfortunate delay but nothing to worry about. By the way, I suppose the long tube IS the plenum. I doubt...

Now that is a big-ass plenum 😅 Huma will fix that, no question about it.

Mine had very small transfer port and block passage. Also trimmed the original valve quite a bit to increase air flow. There's also a few bottle necks in the valve rebound spring area. Nothing wrong experimenting, just don't make stuff weak.

Well it did the usual: bumped up speed significantly. I had tried upping the power to no prevail. After installing the plenum I got way more fpe. Something like 10 to 15 fpe more out of a previously anemic setup. Just enough to smack serious critters. Increasing regulator pressure does very...

I had my own plenum made using Huma reg. It does extend past the step and only takes a little more effort to assemble. Never been any trouble. Mine is old, probably one of the first ones. For what it's worth, the high pressure area can take regulator pressure, obviously, but I wouldn't do it...

Did you factor in the regulator pressure? The 300cc bottle will drop pressure rapidly. You would need more than 150bar to keep things going. Good math though.

Numbers like that are just never going to happen. I wish they would. On a repeater maybe, on a good day, with less than max power. Semi auto uses more air no matter how the reloading is actually done. Maybe they're about to rewrite laws of physics. This is exciting.

Still waiting for them to be available in Europe... Krale? Anyone?

https://milidonis.gr/ανταλλακτικά-αεροβόλων-αεροβόλα-όπλα-1/artemis-αεροβόλα-όπλα-1-1?page=8 They list some parts for the valve in both .22 and .25. The valve body seems to be the same though. I wouldn't worry about the reg or any other stuff when going smaller caliber. I actually believe it...

The valve is caliber specific. One would think hammer spring as well. I would just go with the bigger components. Magazines are about 30$ a piece...

There's supposed to be a pressure release screw. A hex key. I the regulator is somehow locked, use the included tools to slowly unscrew the gauge. You only need to turn a couple of revolutions. Don't try to take it off as long as there's pressure. Stay safe

There may be Power Plenums easily available. It does benefit quite alot. I remember regulator being the worst thing on a Gen 1. So small. Huma did make a difference but it was still a little so so.

I asked Krale to take a look at AVS and Silent Thunder Ordnance. It wouldn't hurt to have more people asking about them.

So many parts 😟