Recent content by WarriorPoet

For sale is my Benjamin Bulldog in good condition! Comes with case, two magazines, and a Donny FL adapter , asking $350 OBO shipped! Prefer Venmo, or Money Order. Local pickup available in Bay area CA Any questions feel free to text or call (415) 761-1569 Thanks in advance!

This listing has been renewed

This listing has been renewed

For sale is my Athlon 3-12 Scope with mount and box, like new condition. Asking $125 OBO shipped, prefer Venmo or PayPal for payment. (415) 761-1569 Thanks in advance!

For sale Caldwell Chronograph in like new condition, comes with case and lighting kit. Asking $120 shipped via venmo (415) 761-1569

This listing has been renewed

3L Carbon fiber air tank for sale, comes with case and quick disconnect hose. Have been using with Home compressor Yong Heng setup, works perfect for a home compressor. Scuba shops will not fill this tank for you...Asking $195 shipped, prefer Venmo for payment. Thanks in advance!

For sale is my Benjamin Bulldog, in good condition. Comes with two magazines, original case, Donny FL adapter with thread protector. Asking $350obo shipped! prefer Venmo or PayPal for payment. Thanks in advance! (415) 761-1569 Owned since new, shoots 81 grain JSB @ 950 feet per second!

I recommend making a pellet trap out of a metal electrical breaker box from Home Depot, filled with Duct Seal from the same electrical department! Mine takes 195 fpe from 12 yards away on the regular and I repack after each target change. Whenever it gets too heavy I dig out and recycle the...

That is normal from my research. Most molds drop slugs oversized, then you size back down to your desired diameter. Plus everything depends on the lead Mixture too, pure lead vs. a mix with tin, etc. For example if I were have bought a .357/38 special mold, they would probably drop at .359 or...

I just started casting my own slugs for my Bulldog, and I am getting decent results. Recycling lead from my ductseal pellet trap makes it possible to never run out of ammo now. I am not even sizing because they drop at .358 using a .356/9mm Lee 125grain mold. Using a bottom pour Lee melting...

It may have been stripped from factory because they use power tools to install most likely. The torque just rounded the hex, and yes he is correct only the rear screw actually keeps the shroud secure to it's mount, the front screws just hold on the end cap and or picatinny.

There should be a threaded version for the people who want that stackable design without the quick detach

Exactly! Here is another one: