Waiker's latest activity

Ok thanks for your thorough. Maybe its time to change the rubber ball. Yesterday i turned the rubber ball sideways. So the flat side...

I am using the slug transfer port. Also the probe is pushing in my slug beyond the transfer port

Yes a decrease and a increase by changing the setting on the micro wheel is happening. Yes the rubber ball is installed but it dont even...

So now i know a lot more. The fault is not the chrony or so. Its zhe barrel itself. I just measured the walter dominator where i knew...

yes true. as i know the the hammer and the reg should be in harmony to each other. the valve adjuster is just to close the valve when...

The goal is to get the smallest burst of high pressure air, to achieve the best velocity and accuracy. The tungsten hammer weight...

I turned the rear reg back to 150bar. I will keep the tungsten hammer in. Cause i think those heavy slugs with 42gr need it. Sure i also...

I have the tungsten hammer weight in my M3. With the reg at 165 bar with stock hammer weight, you would have the hammer spring tension...

short update of mine. Just shot again a view rounds after i reassembled my gun. I think the pocket chrony from fx gives me wrong speeds...

I dont know the exact weight of the tungsten. i think for a .25 cal a 42gr slug is pretty heavy. as far as i know the 42gr slugs from h&n

I bought the 25 cal regularly. i wanted to shoot heavier slugs line the 42gr. So i took the tungsten hammer in the softer spring and the...

Yes the part 52 is correct installed just checkt it. also just whatched the video you sent i will give it maybe tomorrow a try and see...

700fps

These r the current settings i am running cant upload the fotos so macro is on 16 micro is on 3.6 and valve is at 12.85 mm open

Thanks for your reply. I will send the fotos later. And i also have to check if i have the weaker valve return spring built in.