Recent content by Vrodfast

1964.08

508.54

The wiki gauges will work in both applications just reuse the oring on the bottle gauge and the seal on the 1st reg gauge. That’s what I did anyway.

I’ll sand inside the carbon sleeve with a dowel. Thanks for the info. 

Has anyone used the carbon sleeve on a STX .22 heavy? My heavy barrel won’t fit too tight. My standard barrel slides right in.

I changed my .22 out with a Huma when I installed a heavy slug liner and slug power kit. Here’s a photo of the size difference. Huma is on the left. I can’t say it made a difference since I made several changes at once . My main concern was with the pellet port on the other side of the stock...

1964.08

Same here. 

It’s the a bad o-ring in the pump. If you search pump rebuild on Gateway to Airguns forum there is several posts on how to repair. 

My 700mm Barely fits in the case without the moderator. So it the Donny is less than 100mm it should. 

It’s the center of the scope to the center of the barrel. What I do is measure the outside diameter of the scope and the barrel. Divide those in half and add those together with the distance between them. 1/2 scope diameter + 1/2 barrel diameter + distance between = scope height. 

Looks right to me. 

Totally agree!

That’s good to know that its a PayPal thing and not all payment methods. Thanks. 

I zero my m3 @ 50 yards just like you. I’m usually shooting 75 to 125 yards and hold under for shorter distances. I use StrelokPro and my Apple Watch to quickly get it dialed in or use the holdover in the reticle.